Pre-Assembling The Mounting Stand - Bartec PBTC-200 Operation And Installation Manual

Operation and Installation Manual PBTC-200

Pre-assembling the Mounting Stand

 Feed the heating cable through the lower part of the mount-
ing stand.
 Do not fix the mounting stand on the pipe yet.
21-54C3-7D0001/- Notice: Technical data subject to change without notice.
04/2021-EHT-441168 No claims for damage arising from alternations, errors or misprints shall be allowed.
 Slide a trace heater grommet onto the trace heater and into
the seal seat.
 Slide the other trace heater grommet into the free seal
seat.
 Make sure that the trace heater stands out approximately
25 cm. This makes cable preparation easier.
 Ensure that all heating cable feed-throughs of the lower
part of the mounting stand are filled with heating cable
seals
4
5
Page 20 / 45