Table of Contents
Advertisement
Step 12: Disconnect the server interconnect cable
c. Unplug the power cable from the power and cooling module, and
d. If the power cable is not threaded through a cable management arm,
Step 12: Disconnect the server interconnect cable
At the rear of the enclosure, disconnect the purple one-foot server
interconnect cable from the server interconnect port on each server module.
Step 13 (conditional): Remove the upgrade-kit drives
from the enclosure
If the S10 Node includes an upgrade kit, you need to remove the 28
upgrade-kit drives from the enclosure. After removing the drives, you need
to insert four empty drive placeholders.
42
move the cable out of the clasp.
place the power cable in the enclosure accessory box.
If the power cable is threaded through a cable management arm,
leave it there for now. You remove the cable from the arm in
(conditional): "Remove the cable management arms"
page 47 .
Chapter 3: Refurbishing an HCP S10 Node
HCP S Series Node Refurbishment
Step 15
on
Advertisement
Table of Contents
