Table of Contents
Advertisement
5. Optionally, save the session configuration:
a. In the Category field, select Session
b. In the Saved Sessions field, type a name for the session (for example,
c. Click on Save .
After saving a session configuration, you can start a new PuTTY session
with that configuration by double-clicking on the name of the session in
the list of saved sessions.
6. Click on Open .
A PuTTY window opens.
Note: If a message is displayed before the PuTTY window opens, click
on
7. In response to the login prompt in the PuTTY window, enter the
applicable username for the procedure you want to perform.
Tip: If you're prompted for a password at this point, your SSH keychain
does not include the necessary SSH key.
Installing InfraRecorder on the laptop computer
To create a bootable USB flash drive from the HCP S Series operating
system ISO image, you first need to generate the ISO image from the HCP
S Series operating system installation files. These files are available on CD.
You use InfraRecorder to generate the HCP S Series operating system ISO
image. To install InfraRecorder on your laptop computer:
1. Run the ir053.exe file.
For instructions on obtaining this file, see
file"
2. If the User Account Control window appears, click on Yes in the window
to allow the installation program to make changes to your computer.
Server Module 1 - SSH ).
or
to close the message window.
OK
Yes
on page 4 .
Chapter 2: Preparing for HCP S Series Node refurbishment
HCP S Series Node Refurbishment
Installing InfraRecorder on the laptop computer
"HCP S Series Node tools
15
Advertisement
Table of Contents
