Hitachi Content Platform S Series Manual page 5

Step 9: Check for hardware issues
Step 10: Reset the BIOS on the server modules
Step 11: Wipe the drives
Step 12: Shut down the S30 Node
Step 13: Disconnect the server module power cables
Step 14: Disconnect the enclosure power cables
Step 15: Uncable the enclosures
Step 16: Disconnect the server interconnect cable and, if applicable, the BMC
interconnect cables
Step 17: Unrack, disassemble, and pack the server modules
Step 17a (conditional): Remove the server module from the rack
Step 17b (conditional): Remove the inner rails from the server module
Step 17c: Remove the outer server module rails from the rack
Step 17d (conditional): Insert the inner server module rails into the outer
rails
Step 17e: Remove the server module cover
Step 17f: Remove the riser card from the server module
Step 17g: Detach the four-port Ethernet PCI card from the riser card
Step 17h (conditional): Detach the two-port Ethernet SFP+ PCI card from
the riser card
Step 17i: Detach the SAS PCI cards from the riser card
Step 17j: Reinsert the riser card into the server module
Step 17k: Remove the SSDs from the server module
Step 17l: Remove the airflow baffle from the server module
Step 17m: Remove the memory cards from the server module
Step 17n: Remove the heat sinks from the server module
Step 17o: Remove the CPUs from the server module
Step 17p: Reinsert the airflow baffle into the server module
Step 17q: Put the cover back on the server module
Step 17r: Pack the server module
Step 18: Unrack and pack the enclosures
Step 18a (conditional): Prepare the enclosure carton
Step 18b (conditional): Remove the upgrade-kit drives from the enclosure 115
Step 18c (conditional): Remove the front panel and light pipe assembly
from the enclosure
Step 18d (conditional): Remove the cable management arms
Step 18e (conditional): Remove the enclosure from the rack
Step 18f (conditional): Remove the inner rails from the enclosure
Step 18g (conditional): Remove the outer enclosure rails from the rack
Step 18h (conditional): Attach the extenders to the outer enclosure rails
Contents
HCP S Series Node Refurbishment
74
77
77
80
80
80
81
82
82
83
85
85
87
88
89
91
93
95
98
99
103
103
104
105
112
113
113
114
115
118
120
122
122
123
124
v