Table of Contents
Advertisement
20. In response to the confirming message, enter y .
The OS installer wipes the drives. This process can take up to ten
minutes. While the installer is wiping the drives, it reports its progress
in the system console, and the light on the USB flash drive either blinks
or is lit solid.
When all the drives have been wiped, the light on the USB flash drive
turns off, and the server module reboots.
21. When the light on the USB flash drive turns off, remove the drive from
the USB port. Be sure to do this before the server module finishes
rebooting.
After the server module reboots and you have removed the USB flash
drive, you should see the message shown below in the system console.
This message indicates that the wipe was successful.
If you did not remove the USB flash drive in time, this message does not
appear. In this case, you need to:
a. Use the rocker switch on each power and cooling module to power the
power and cooling modules off.
b. Repeat this entire step (
22. If you have not yet performed the wipe procedure on the second server
module:
a. Use PuTTY to establish a serial connection to the second server
module, as described in
Nodes only)"
Chapter 3: Refurbishing an HCP S10 Node
HCP S Series Node Refurbishment
Step 8: "Wipe the drives"
"Using a PuTTY serial connection (S10
on page 8 .
Step 8: Wipe the drives
on page 33 ).
39
Advertisement
Table of Contents
