Hitachi Content Platform S Series Manual page 4

Preparing a USB flash drive from the HCP S Series operating system
ISO image file
Chapter 3: Refurbishing an HCP S10 Node
What you need for refurbishing an S10 Node
Step 1 (conditional): Unpack the enclosure
Step 2 (conditional): Insert the upgrade-kit drives into the enclosure
Step 3 (conditional): Connect the server interconnect cable
Step 4 (conditional): Connect the power cables
Step 5: Connect the PDUs to the power sources
Step 6: Check for hardware issues
Step 7: Reset the BIOS on the server modules
Step 8: Wipe the drives
Step 9: Shut down the S10 Node
Step 10 (conditional): Prepare the enclosure carton
Step 11: Disconnect the power cables
Step 12: Disconnect the server interconnect cable
Step 13 (conditional): Remove the upgrade-kit drives from the enclosure
Step 14 (conditional): Remove the front panel and light pipe assembly from the
enclosure
Step 15 (conditional): Remove the cable management arms
Step 16 (conditional): Remove the enclosure from the rack
Step 17 (conditional): Remove the inner rails from the enclosure
Step 18 (conditional): Remove the outer enclosure rails from the rack
Step 19 (conditional): Attach the extenders to the outer enclosure rails
Step 20 (conditional): Insert the inner enclosure rails into the outer rails
Step 21: Pack the enclosure
Step 22 (conditional): Unrack and pack the PDUs
Chapter 4: Refurbishing an HCP S30 Node
What you need for refurbishing an S30 Node
Step 1 (conditional): Unpack the enclosures
Step 2 (conditional): Insert the upgrade-kit drives into enclosures
Step 3 (conditional): Unpack the server modules
Step 4 (conditional): Connect the server interconnect cable
Step 5: Cable the enclosures
Step 6 (conditional): Connect the enclosure power cables
Step 7 (conditional): Connect the server module power cables
Step 8: Connect the PDUs to the power sources
iv
Contents
HCP S Series Node Refurbishment
18
21
23
24
26
29
29
30
30
32
33
40
40
41
42
42
46
47
49
50
51
52
54
55
55
57
60
62
64
68
69
69
73
73
74