Table of Contents
Advertisement
S Y S T E M M E N U
PERSONALITY - Reset Default (011)
CAUTION! ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION. SAVED
WHITE BALANCE IS ERASED AFTER A RESET IS PERFORMED.
This function restores all fixture settings to the factory default settings. The password is
011 and must be entered each time a reset is performed.
EFFECT ADJUST – Test Channel
Auto test each individual channel function independently from the DMX control board.
EFFECT ADJUST – Manual Control
Select and manually test and fine adjust each individual channel function independently from
DMX control board. This function will center PAN and TILT motors and set dimmer to 100%.
PAN and TILT functions will still operate if the fixture needs to be positioned to a flat clear
surface. With the individual functions, you can focus the light on a flat surface (wall) and
perform fine adjustments.
EFFECT ADJUST – Calibration
CAUTION! ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THIS FUNCTION.
This function allows small adjustments to be made to the Pan, Tilt, and Zoom movements
to compensate for wear, or in the event that a sensor has been knocked slightly out of place.
Because improper use of this function can result in undesired operation, this function has
been password protected. The password is 050 and must be entered each time the calibration
menu function is entered. Because calibration is an extremely delicate procedure, instructions
on performing this action are left out of this manual. If you are a first-time calibrator,
please contact our customer support team for step-by-step instructions.
USER MODE SET – Edit User Mode
Create user defined channel orders allowing the fixture to match the channel order of other
fixtures on the market for easier operation. A total of three user modes may be configured:
User Mode A, User Mode B, and User Mode C.
22
Advertisement
Table of Contents
