Norton Clipper CS 401 P13 Operating Instructions Manual page 23

VERS.2015.07.21

Install the plug finger tight to seat the washer, then tighten with a plug wrench (an additional
½ turn if a new plug) to compress the sealing washer. If you are reusing a plug, tighten 1/8-
1/4 turn after the plug seats.
Fuel line
To service the fuel line, follow these
instructions:

Drain the fuel into a suitable container,
and remove the fuel tank.

Disconnect the fuel line, and unscrew
the fuel filter from the tank.

Clean the filter with solvent, and
check, that the
undamaged.

Place the O-ring on the filter and
reinstall. Tighten the filter to 2N.m.
After reassembly, check for fuel leaks.
Further maintenance
For further maintenance, please contact the nearest engine maintenance centre.
filter screen is
CS 401_MAN_EN
23