Norton Clipper CS 401 P13 Operating Instructions Manual page 22

VERS.2015.07.21

Cyclone filter
When the cyclone housing becomes dirty,
unscrew the three special pan screws and
wipe or wash the components with water.
Next, thoroughly dry the components and
carefully reassemble them.
When reinstalling the cyclone, ensure that
the tab on the air intake fits properly into
the groove in the pre-cleaner cap.
Be careful to install the air guide in the
proper direction.
Fuel strainer cup
To service fuel strainer cup, follow these
instructions:

Turn off the fuel valve and remove the
strainer cup.

Clean the strainer cup with solvent.

Install the O-ring and strainer cup.

Tighten the strainer cup to 4N.m.
Spark plug
To service the spark plug, follow these
instructions:

Visually inspect
Discard the plug if the insulator is
cracked or chipped.

Remove carbon or other deposits with
a stiff wire brush.

Measure the plug gap with a wire-type
feeler gauge. If necessary, adjust the
gap by bending the side electrode.

Make sure the sealing washer is in
good condition; replace the plug if
necessary.
22
the spark plug.
CS 401_MAN_EN