Norton Clipper CS 401 P13 Operating Instructions Manual page 18

VERS.2015.07.21
5.2.2 Cutting the floor
You can now start the engine.
To make your cut,

Turn the depth hand wheel until the blade slightly touches the floor.

Open water valve to control the amount of water required for the type of blade, using 15 to
25l/min for wet cutting and 1-2l/min for dry cutting (dust control). Check for minimum water
level regularly when using the water tank.

To lower blade into the cut, turn hand wheel clockwise. Each turn of the hand wheel will
raise or lower the blade by 10mm.

Once the required depth of cut is reached, push the machine forward with steady and gentle
pressure and follow the line with the cutting guides. The feed speed must be adjusted
depending on the material being cut, and depth of cut.

At the end of the cut, raise the blade out of the cut by turning the hand wheel anti-clockwise,
shut-off the water and switch off the engine.
18
CS 401_MAN_EN