Norton Clipper CS 401 P13 Operating Instructions Manual page 21

VERS.2015.07.21
Air Cleaner
CS 401 has a dual type filter.
To service the air cleaner filter, remove
the blade and the water tank from the
machine, and drive the engine support in
its lowest position using the hand wheel.
Follow these instructions:

Remove the nut, air cleaner cover and
wing nut.

Remove the pre air cleaner elements
and separate them.

Carefully check both elements for
holes or tears and replace if damaged.

Paper element: tap element lightly
several times on a hard surface to
remove excess
compressed air lightly through the filter
from the inside out. Never brush the
dirt off; brushing will force dirt into the
fibres.

Foam element: clean in warm soapy
water, rinse and
thoroughly. Dip the element in clean
engine oil and squeeze out all the
excess. The engine will smoke during
initial start-up if too much oil is left in
the foam.

Shine a light through the elements,
and inspect them carefully. Reinstall
the elements if they are free of holes
and tears.
dirt or blow
allow drying
CS 401_MAN_EN
CS401 P13
CS401 P9
21