NEC Express5800 Series User Manual page 45

Keyboard language setting
The console drawer is equipped with 103 English(US) Keyboard (N8143-110 Keyboard Unit (US)). Keyboard
language setting is set to English(US) in the factory condition.
It can be replaced with optional N8143-109 Keyboard Unit (JP) or N8143-111 Keyboard Unit (UK).
After keyboard unit is replaced, follow the procedures below to change keyboard language setting
(1) Connect the console drawer to the server, then start the server.
(2) Keep holding down [HOT-KEY] switch for 5 seconds or more to start keyboard language setting mode. NUM
LOCK, CAPS LOC, and SCROLL LOCK LEDs flash in keyboard language setting mode. There are 3 different
flashing patterns depending on the keyboard unit type (JP/US/UK).
N code
N8143-109 Keyboard Unit (JP)
N8143-110 Keyboard Unit (US)
N8143-111 Keyboard Unit (UK)
(3) Enter 2 digit value of desired keyboard language.
N code
N8143-109 Keyboard Unit (JP)
N8143-110 Keyboard Unit (US)
N8143-111 Keyboard Unit (UK)
(4) Confirm flashing pattern of the LED matches to the keyboard language you set.
(5) Release [HOT-KEY] switch. NUM LOCK, CAPS LOCK, and SCROLL LOCK LEDs stop flashing and keyboard
language setting mode ends.
Express5800 Series 17.3-inch LCD Console Drawer (1port) User's Guide
Language
NUM LOCK×1⇒CAPS LOCK×1⇒Off⇒･･･
Japanese
repeats continuously
NUM LOCK×3⇒SCROLL LOCK×3⇒Off⇒･･･
English
(US) repeats continuously
NUM LOCK×3⇒SCROLL LOCK×2⇒Off⇒･･･
English
(UK) repeats continuously
Keep holding dow n [HOT-KEY] sw itch w hile you configure and
Note

check the setting in keyboard language setting mode.
If you release [HOT-KEY] sw itch, keyboard language setting mode

w ill end.
Language Setting value
Japanese 15
English
33
(US)
English
32
(UK)
Note
You can input the setting value w ith either ten key or letter key.
Flashing pattern
45