Table of Contents
Advertisement
Chapter 4 System Settings
The node has network ports. The default IP address of the node is 192.168.*.*,
mask 255.255.0.0, and gateway 192.168.*.1 (The IP address and gateway can be
changed)
Nodes and control computers are connected to the LAN as shown below.
Three major pieces of software are required for onsite distributed commissioning, as
shown below.
① Node parameter setting software: UMPlatform, green version.
② System design and configuration software: Designer, green version.
③ Client: WinClient,IOS distributed system control platform, Windows version is the
green version.
Note: Need to put on the firewall, set reference
8
Advertisement
Table of Contents
Need help?
Do you have a question about the IC2+ and is the answer not in the manual?
Questions and answers