Sub Memory - Panasonic PT-DW7700K Operating Instructions Manual

Dlp based projector
Table of Contents

Advertisement

Registration of input signal data

Sub memory

The projector is provided with a sub memory function to register plural pieces of image adjustment data even they
are determined to be the same signal by the frequency and form of the synchronization signal source.
Use this function when the user needs adjustment of picture quality such as aspect switching and white balance
using the same signal source.
Sub-memory contains all data that can be adjusted by signals such as screen aspect ratio and image adjustment
data (BRIGHT, CONTRAST etc.).
How to register into sub memory
A new signal cannot be registered into sub memory. A new signal must undergo signal registration.
SUB MEMORY LIST
1- 1:SXGA60-A1
1- 2:SXGA60-A2
1- 3:
– – –
1- 4:
– – –
1- 5:
– – –
1- 6:
– – –
1- 7:
– – –
1- 8:
– – –
:SELECT ENTER:CHANGE STD:DELETE
REGISTER SUB MEMORY?
NAME:
MEMORY NO:
S.S.NO:
INPUT NO:
fH:
fV:
SYNC. STATE:
ENTER:EXECUTE
Procedure to switch to sub memory
Press the "USER" button on normal screen (menu is not displayed).
The screen will show a list of the sub-memory registered for the currently entered signal.
In the "SUB MEMORY LIST", select the sub-memory signal to be switched using the
,
,
and
Press the "ENTER" button.
Signal will be switched to the one that was selected in Step
How to erase sub memory
The currently selected SUB MEMORY is deleted by pressing the standard button (STD) at the "REGISTERED SIGNAL
LIST" or the "SUB MEMORY LIST".
42
SXGA60-A1
– –
– – –
RGB1
48.00kHz
60.00Hz
H(POS)
V(POS)
MENU:ESC
buttons.
Press the "USER" button on normal
screen (menu is not displayed).
(A "Check sub-memory registration" screen will
appear if sub-memory has not been registered.)
The screen will show a list of the sub-memory
registered for the currently entered signal.
Select the SUB MEMORY number
stored with the
buttons in the "SUB MEMORY LIST".
Press the "ENTER" button.
A "Change registered signals" screen will appear.
Press the "ENTER" button.
Note
• To rename a registered signal, perform step
page 41.
.
,
,
and
on

Advertisement

Table of Contents
loading

Table of Contents