Husqvarna AUTOMOWER 320 NERA Operator's Manual page 18

min 30 cm / 12"
11. Connect the power supply cable to a 100-240V
power outlet.
Note:
The product can be put in the charging
station to charge while you install the boundary
wire.
12. Put the low-voltage cable in the ground with stakes
or bury the cable. Refer to
position with stakes on page 19 or Introduction on
page 6 .
13. Connect the wires to the charging station after
the installation of boundary wire and guide wire is
complete. Refer to
page 18 and To install the guide wire on page
18 .
14. Attach the charging station to the ground with the
supplied screws after the guide wire is installed.
To lift and move the product on page 5 .
Refer to
3.5.6 To install the boundary wire
CAUTION:
a coil. The coil causes interference with the
product.
1. Put the boundary wire around all of the work
area. Start and complete the installation behind the
charging station.
2. Open the connector and put the boundary wire in
the connector.
3. Close the connector with a pair of pliers.
18 - Installation
To put the wire into
To install the boundary wire on
Do not put remaining wire in
4. Cut the boundary wire 1-2 cm / 0.4-0.8 in. above
each connector.
5. Push the right connector onto the metal pin on the
charging station with the mark "AR".
6. Push the left connector onto the metal pin on the
charging station with the mark "AL".
3.5.7 To install the guide wire
CAUTION:
screw terminal block that is insulated with
insulation tape are not satisfactory splices.
Soil moisture will cause the wire to oxidize
and after a time result in a broken circuit.
1. Open the connector and put the wire in the
connector.
2. Close the connector with a pair of pliers.
3. Cut the guide wire 1-2 cm / 0.4-0.8 in. above each
connector.
4. Push the connector onto the metal pin on the
charging station with the mark "G1/G2/G3".
Note:
You can only use 2 guide wires G1/G2 for
®
Automower 320/430X NERA.
5. Disconnect the charging station from the power
outlet.
6. Put the end of the guide wire at the eyelet on the
boundary wire.
7. Cut the boundary wire with a pair of wire cutters.
8. Connect the guide wire to the boundary wire with a
coupler.
Twinned cables, or a
2071 - 001 - 29.03.2023