Installation - Husqvarna AUTOMOWER 320 NERA Operator's Manual

4.3.2 Object avoidance
Object avoidance is only available for Automower
430X/450X NERA.
The products senses objects on the lawn that is higher
Object avoidance function
than the grass with the
enabled. When the product senses an object on the
lawn, the product turns and continues to cut in a
different direction. You can disable the
function if it is unsatisfactory for your work area.
Note:
Object avoidance can cause that the grass is
not cut around objects. The sensors can also sense high
grass or flowers in the work area as objects.
4.3.3 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
Weather timer , it is recommended
When using
to make as much operating time as possible available
Weather timer . Do not restrict the schedule more
for
than necessary.
The first operation of the day is set by the schedule
settings. The product always complete 1 mowing cycle,
Weather timer selects if the product will
and then
continue to operate or not.
Note:
Weather timer is reset if the product does not
operate for more than 50 hours, or if a
settings is done. Weather timer is not changed if a Reset
of schedule settings is done.
4.3.4 ECO mode
ECO mode disables the signal in the boundary wire,
guide wire and the charging station, when the product is
parked or is charging. The LED indicator of the charging
station flashes green when the loop signal is disabled.
2071 - 001 - 29.03.2023
Note:
interference with other equipment, for example hearing
loops or garage doors.
Note:
you must first enable the loop signal.
4.3.4.1 To enable the loop signal
1.
2.
3.
4.
®
5.

4.4 Installation

Object avoidance
In
the product.
4.4.1 To find the charging station
The product can be set to search for the charging station
in 3 methods:
•
•
•
The factory setting is set to use the 3 search methods
at the same time. Use the factory setting to find the
charging station as fast as possible and to keep the risk
of tracks on the lawn to a minimum. The product always
starts to search for the
a specified time interval, it also uses
Follow boundary wire .
Causes why the product cannot follow the wire:
•
•
Reset of all user
4.4.1.1 Charging station signal
For some installations it is necessary to decrease the
signal of the charging station. For example when the
charging station is put near an obstacle, such as a bush
or a wall. The product finds the charging station signal
on the other side of the obstacle and tries to find the
charging station, but the object prevents it to go to the
ECO mode to save energy and to prevent
Use
To start the product manually in the work area
Set the product to ON.
Push the STOP button.
Wait 2 seconds and then remove the product from
the charging station.
Make sure that the LED indicator of the charging
station is solid green.
Put the product where you want it to start to cut.
Installation you can change the installation settings of
Charging station signal
Follow boundary wire
Follow guide wire
Charging station signal . After
Obstacles near the wire have not been isolated.
The charging station, the boundary wire or the
guide wire are not installed according to the
To install the charging station on
instructions in
page 17 , To install the boundary wire on page 18
To install the guide wire on page 18 .
and in
Follow guide and
Settings - 21