Husqvarna AUTOMOWER 320 NERA Operator's Manual page 30

WARNING:
screws when you replace the blades. The
used screws can wear quickly and make the
blade come loose, this can cause serious
injury.
Replace worn or damaged blades for a safe operation.
Replace the blades regularly for a satisfactory cut result
and a low energy use. All 3 blades and screws must
be replaced at the same time to get a balanced cutting
system.
6.5.1 To replace the blades
1. Set the product to OFF.
2. Put the product with the blade disc up on a clean
and soft surface.
3. Rotate the skid plate until the holes align with the
screws for the blade.
4. Remove the 3 screws.
5. Remove the 3 blades and the screw.
6. Attach 3 new blades and screws. Use Husqvarna
original blades.
7. Make sure that the blades can move freely.
30 - Maintenance
You must replace the
2071 - 001 - 29.03.2023