Table of Contents
Advertisement
Message
Guide 1 not found
Guide 2 not found
Guide 3 not found
GPS navigation prob-
lem
Weak GPS signal
7.2 LED indicator of the charging station for boundary wire installation
The LED indicator of the charging station is green when the installation is correct. If the LED indicator of the charging
station is not green, follow the troubleshooting table below.
Speak to your local Husqvarna representative or go to www.husqvarna.com for more information.
LED indicator
Constant green
Flashes green
Flashes blue
Flashes red
Constant red
2369 - 001 - 05.02.2024
Cause
The guide wire you have installed before is
not found.
Problem with the GPS assisted navigation
equipment.
The GPS signal is blocked in large parts of
the work area.
Cause
The signals of the charging station are good.
The signals of the charging station are good
ECO mode is enabled.
and
The boundary wire is not connected to the
charging station.
The boundary wire is damaged.
Interference in the antenna of the charging
station.
Error in the circuit board or incorrect power
supply in the charging station.
Action
Examine if the guide wire is not correctly
connected to the charging station or the
boundary wire. Examine if there is a break
in the guide wire. Refer to
the loop wire on page 39 .
Restart the product. If the problem stays,
speak to your authorized service center.
If possible, remove objects that can cause a
blockage of the GPS signal.
Disable the GPS navigation function and use
the lawn coverage function. Refer to
coverage on page 22 .
Action
No action is necessary.
No action is necessary.
Connect the boundary wire to the charging
station.
Replace the damaged section of the boun-
dary wire with new boundary wire.
Speak to your local Husqvarna representa-
tive.
The error must be corrected by an authorized
service technician. Speak to your local Husq-
varna representative.
Finding breaks in
Lawn
Troubleshooting - 37
Advertisement
Table of Contents
