Transportation, Storage And Disposal; Transportation; To Put The Product Into Storage; To Put The Charging Station Into Storage - Husqvarna AUTOMOWER 320 NERA Operator's Manual

8.1 Transportation

The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
• For how to remove the battery, refer
to the complete Operator's manual on
www.husqvarna.com.

8.2 To put the product into storage

CAUTION:
before you put the product into storage. If
the battery is not fully charged it can cause
damage to the battery.
• Charge the product fully. Refer to
battery on page 26 .
• Set the product to OFF. Refer to
to OFF on page 26 .
• Clean the product. Refer to
page 28 .
• Put the product in a dry, frost-free area.
• Put the product with all wheels on level ground or
use a wall hanger.
• We recommend to put the product in the package
of the product. You can also hang the product on a
Husqvarna wall hanger. Speak to your Husqvarna
representative for more information about available
wall hangers.
8.3 To put the charging station into
storage
You can remove the top of the charging station and put
it into storage. It is not necessary to put the baseplate of
the charging station into storage.
1. Tilt the top of the charging station and open the
hatch.
2. Disconnect the power supply unit from the
charging station and from the power outlet.
3. Disconnect the cable.
2071 - 001 - 29.03.2023

8 Transportation, storage and disposal

Charge the battery fully
To charge the
To set the product
Clean the product on
4. Remove the grommet with the cables.
5. Pull the top of the charging station up and remove
it.
6. Close the sealing lid.
7. Close the hatch.
8. Put the power supply unit and the top of the
charging station in a dry, frost-free area.
8.4 To install the charging station after
storage
1. Open the hatch.
2. Push in the sealing lid.
3. Attach the top of the charging station.
4. Tilt the top of the charging station.
5. Put the grommet with the cables into position.
6. Connect the cable to the charging station.
7. Connect the power supply unit to the power outlet
and to the charging station.
8. Close the hatch.

8.5 Disposal

• Obey the local recycling requirements and
applicable regulations.
Transportation, storage
and disposal - 41