Data Transfer Verification; Time Window Connection - Honeywell EK205-M Operating Instructions Manual

80
- Enter the value "1" in
"Transfer changes to
8.3

Data transfer verification

The communication link (e.g. call window, modem used) to a destination must be established
before the data can actually be transmitted. You can program six separate connections.
i
To parameterize the EK205-M, you will require a connection cable for the optical interface as
well as the enSuite program, which can be downloaded free of charge from
instromet.com.
The paths described below can be found
in enSuite under:
online" > "Parameters" >
"Interfaces"
All connections are inactive by default and preset as follows, as can be seen
in enSuite under:
"Call time
windows"
Connection
1 Time window
2 Time window
3 Time window
4 Time window
5
6

8.3.1 Time window connection

The major parameters for activating a time window connection are listed below. For
parameterization, go to the following sub-menu in enSuite:
"Connections"
Time
window
connection
Cycle Cycle of a regular time window connection (e.g. hourly, daily, weekly, monthly)
Start Start of a time window connection (e.g. daily at 00:00 or another time)
End End of a time window connection (e.g. daily at 23:59 or another time)
StCon Current status of this connection
If the conditions for activating the time window connection are satisfied, then the interface is
opened and the EK205-M is ready for reception. If a modem is connected to this interface, the
EK205-M will only be ready for reception after a further 30 seconds.
The conditions for activating a time window connection are as follows:
- Is the current device time within the parameterized time window?
- Does the supply to the EK205-M correspond with the parameterization of the connection?
-
"Reset terminal interface
device" icon at the top of the enSuite window.
"Parameterize
"Parameterize online" > "Parameters" > "Interfaces" >
Event type Interface
Terminal / ext. modem
Terminal / ext. modem
Terminal / ext. modem
Terminal / ext. modem
Time Terminal / ext. modem
Time Terminal / ext. modem
> "Connection 1" to ... >
"ResI2"" and then click on the
Power supply
Ext. power supply
Ext. power supply
"Connection
6"
Meaning
Data transfer
www.elster-
Always
Always
Always
Always