Connect Outputs Of The Ek205-M - Honeywell EK205-M Operating Instructions Manual

40
Fig. 13

6.2.6 Connect outputs of the EK205-M

The line diameter for connection of the inputs of the EK205-M is
0.8 ... 1.0 mm (AWG 20 – 18).
Various instruments can be connected to the digital output of the EK205-M To this
end, the outputs are preset (see section 6.3.1.10)
CAUTION!
Danger from incorrect device connection!
Ensure that the outputs have the correct polarity to prevent damaging the outputs.
Connect the outputs in safe assembly area only. Modem power needs to be
unplugged and removed from the enclosure to access the output connections in the
field.
Fig. 14
Connect the power supply to the "Uext" terminal 1 of the
EK205-M.
The polarity should be taken into consideration, i.e. connect the
"+" of the power supply unit to the "Uext +" terminal and "-" to
"Uext".
1
1. Connect the downstream device to the required digital outputs
(terminals DA1 and DA2) on the EK205-M (see Fig. 14).
2. A terminal cover is supplied in the accessories bag to seal the output
terminals. If necessary, place these over the terminals and screw
tight. Then affix a seal to the retaining screw (see section 6.3.2).
3. If necessary, set the cp value (pulse constant) for the pulse outputs
as described in section 6.3.1.10.
Installation, connection and commissioning