Table of Contents
Advertisement
108
Message
Description, process
online
Data is currently being transmitted via an interface (modem, optical interface
or terminal interface).
If this message is displayed, the "o" will flash in the "Status" field of the
display (see section 9.3.4).
E2-HinwSig.
If an input has been configured as a signal input, this message will be
displayed if an active signal appears at the corresponding terminal (e.g.,
terminal DE2).
The input configuration can be adjusted using the enSuite parameter
program.
Remote clock
The Volume Conversion Device has started to set its clock via RDT. It is
deleted again as soon as this could be carried out successfully.
If this report remains entered for more than a couple of minutes, the
Automatic setting of the clock via RDT function is activated but could not be
executed. In this case, please contact the Elster customer service (see
section 1.4 Customer service).
Cal.lock o.
The calibration lock is open.
In normal operating conditions, the calibration lock should be closed so that
unauthorized changes cannot be made.
To close the calibration lock, please go to
and enter the value "0".
Admin.lock
The administrator lock is open.
Cust.lock o.
The customer lock is open.
Bat. operat.
The EK205-M is in battery mode.
This signal is primarily used to inform a remote data transmission system
that the batteries run down more quickly during long periods of data
transmission.
Dayl.Sav.Tim
The time displayed in volume convertor is daylight saving time.
The switchover mode can be changed using the enSuite software.
Call Win.1
The specified call pickup time window is active, i.e., the Volume Conversion
Device will accept data transmission calls.
Call Win.2
Call Win.3
Call Win.4
Call Win.5
Call Win.6
call time1
The specified call time is active, i.e., the EK205-M shall make a data
call time2
transmission call to the remote terminal.
Ctrl.
St.ES
Faults
Advertisement
Table of Contents
