Honeywell EK205-M Operating Instructions Manual page 101

Maintenance
10.2.1.2 Replace and connect modem battery
Fig. 42
2
Fig. 43: EK205-M with lid removed
Ensure that the new modem battery is installed correctly and sits tight inside the
EK205-M.
CAUTION!
Damage to property caused by improper device closure!
If the device is not properly closed cables can get pinched and cause damage.
Therefore:
– During closing, ensure the correct position of the cable ducts.
1
4
3
1. Loosen the four housing screws (Fig. 42:
1).
2. Open the lid of the EK205-M.
3. Mark the old modem battery with a felt
pen or label, for instance.
4. Disconnect the modem battery from the
modem assembly (Fig. 43: 3).
5. Remove the modem battery (Fig. 43: 2).
from the modem battery holder (Fig. 43:
4).
6. Place the new modem battery inside
(Fig. 43: 2) and ensure that the battery is
correctly fitted in the modem battery
holder.
7. Remove the old modem battery and
dispose of it correctly.
8. Close the housing using the intended
screws (Fig. 42: 1).
101