Table of Contents
Advertisement
94
9.4.3.9 Qm – actual flow rate
Current actual flow rate (measurement flow rate).
The measurement insecurity of the operating load displayed depends on whether a pulse
transducer is connected:
For connected pulse transducer:
With a pulse distance of a maximum of 15 minutes (at least four pulses per hour) and
cp.I1 1, the measurement uncertainty of Qm is a maximum of 1%. For a pulse period of more
than 15 minutes, Qm = 0 is displayed. After changing the gas flow, the precise value can only be
displayed when the gas meter has sent at least two pulses.
9.4.4 Admin tab (administrator)
This tab is used to display and check special device settings or statuses. The application is
intended for the measurement location operator.
Display
18
User values
Volume
Volume conversion
Measured values
Archives
Status
Date and time
Batteries
Inputs
Outputs
Interfaces
Device settings
Identification
18
In the User values submenu, the user can set via the enSuite parameterization software up to 10 and within this list in another
submenu up to 12 freely programmable parameters.
Meaning
Submenu for user-specific parameters
Submenu for volumes and associated parameters
Submenu for conversion and associated parameters
Submenu for measurement values and associated parameters
Submenu for archives located in the device
Submenu for current status, status tab and logbooks
Submenu for date and time and associated parameters
Submenu for device batteries and associated parameters
Submenu for the inputs and associated parameters
Submenu for all outputs and associated parameters
Submenu for the interfaces in the device
Submenu for general device settings
Submenu for the identification of the gas system
Operation
Advertisement
Table of Contents
