Table of Contents
Advertisement
2.7.3 POGO STICK WALL MOUNT
An optional kit allows pogo stick cable hangers to be mounted next to a charger.
Refer to Figure 8 below.
1. From the kit, select the right angle mounting bracket, the spring
clamping nut, the washers and the machine screw.
2. Place the nut in the channel, then orient the bracket with the
smaller leg on the bracket and the larger leg facing up.
3. Place the lock washer on the screw, then the flat washer, and insert
the screw through the bracket and into the clamping nut. Tighten
firmly.
4. Remove the nut and any washer from the pogo stick threaded rod,
insert the rod through the bracket leg, then place the mounting
hardware back on the rod and tighten firmly.
2.7.4 STACK LIGHT
1. See Figure 9. On the top of the cabinet, at the left rear corner,
drill five holes at the locations shown with the hole dimensions as
shown in Figure 10. Do not allow metal shavings to enter cabinet.
2. In order, secure the mount to the cabinet with the included
hardware, run the stack light wires through the pole, secure the
light to the pole with the lock, insert the wires into the cabinet,
then insert the pole into the mount.
Figure 7: Pedestal Mount
Figure 8: Pogo Stick Wall Mount
14
Advertisement
Table of Contents
