Table of Contents
Advertisement
2.4.1 WALL MOUNT
The chargers are designed for wall mounting. Refer to Table 1 above for your
charger's weight to determine the correct mounting hardware.
The cabinets are built according to the number of charger modules required by
your facility. Figure 2: Single and Triple Chargersbelow shows for a single module
and multiple modules.
Figure 2: Single and Triple Chargers
Charger must not be mounted in such a manner that causes warpage, especially
on the rear surface. The cabinet assembly and charger modules each ship in
separate containers.
Charger minimum clearances are 1' to the left, 3' on the right for service access, 3'
below, and 0 above.
Figure 3: Wall Mount
If you are mounting the charger on a standard wall with studs and drywall
covering where the studs are 16" on centers, use a stud finder to determine and
mark stud locations. After locating the studs, mount two Unistrut® channels
horizontally to accommodate the fastener holes in the cabinet. (See Figure 1). At
a minimum, run the Unistrut horizontally across 3 studs. Use the same channels if
you are mounting to concrete block walls. See Figure 3: Wall Mount.
9
Advertisement
Table of Contents
