Table of Contents
Advertisement
Personal protective equipment shall be used when and where required.
•
Do not install or place unit on, over or near combustible surfaces.
•
Do not install unit near flammables.
•
Do not block air intake or exhaust.
•
Do not overload building wiring - be sure power supply system is properly
sized, rated and protected to handle this unit. Use only on circuits provided
with the minimum wire size specified in the installation section.
•
Protective bollards or Armco barriers should be installed where charging
equipment location is subject to damage from vehicle activity.
•
Do not install unit where it will be exposed to direct sunlight.
•
To avoid shock hazard, only install cables approved by PosiCharge™ for
indoor use.
•
Do not subject the cable or coupler to damage or stress. Do not step on the
coupler cable.
•
Do not hang from the coupler cable.
•
Do not disassemble the ProCore.
•
Follow the National Electrical Code (NEC) and local codes. NEC and local
codes take precedence. If any instructions in this manual conflict with NEC or
local codes, contact Webasto Inc. for further information.
CONTACT POSICHARGE'S CUSTOMER SERVICE DEPARTMENT PRIOR
TO PERFORMING ANY SERVICE ON THE UNIT.
4
OSHA INSTRUCTION STD 1-11.4
OCTOBER 30, 1978
"Battery charging" areas where power industrial
truck batteries are charged only—no maintenance is
performed, batteries are not removed from the trucks
and no electrolyte is present in the area—are not
subject to the requirement of 29 CFR 1910.178 (g) (2).
The charging areas shall be in compliance with 29 CFR
1910.178 (g) (1), (8), (9), (10), (11) and (12).
1-866-767-4242
Advertisement
Table of Contents
