Table of Contents
Advertisement
Malfunction
Control lamp does not light up.
The line voltage is applied.
Control lamp does not light up.
* Have these tasks carried out by the service department of your Wacker Neuson representative per-
son.
100_0101_ts_0006.fm
Cause
GFCI has turned off the
machine.
Machine malfunction.
Water in thedrive motor.
Defect in the drive motor.
No line voltage.
GFCI isdefective.
Plug is defective.
Control lamp is defective.
55
12 Malfunctions
Remedy
1. Pull the plug from the plug re-
ceptacle.
2. Check power cable for dam-
age – if damaged, have it re-
placed. *
3. Insert the plug into the plug
receptacle.
If the fault is not remedied, have
the machine repaired. *
Have the machine repaired. *
1. Pull the plug from the plug re-
ceptacle.
2. Check power cable for dam-
age – if damaged, have it re-
placed. *
3. Insert the plug into the plug
receptacle.
Have the machine repaired. *
Have the machine repaired. *
Have the machine repaired. *
Advertisement
Table of Contents
