Wacker Neuson M1000 Operator's Manual page 47

Checking the carbon brushes
Inserting the carbon brushes
1. Install carbon brush (on both sides of drive motor). Pay attention to the origi-
2. Screw on cap with o-ring and tighten with a screwdriver hand tight.
Note: If you have installed new carbon brushes, the drive must be run for ap-
100_0101_mt_0007.fm
Check that both carbon brushes are at least the minimum length.
Note: If one carbon brush is smaller than the minimum length, both carbon
brushes must be replaced.
nal position and location of used carbon brushes, to avoid damage and spar-
king on the collector.
prox. 5minutes without the flexible shaft attached.
47
11 Maintenance