Safety During The Operation Of Modular Internal Vibrator; Maintenance - Wacker Neuson M1000 Operator's Manual

Uncoil the cable drum completely (Accessories)
Danger of fire due to wound cable drum.
Uncoil the cable drum completely before operation.
Protecting the power cable
Do not use the power cable to pull or lift the machine.
Do not unplug the power cable by pulling on the cable.
Protect the power cable from heat, oil and sharp edges.
If the power cable is damaged or the plug is loose, have it replaced immediately
by your Wacker Neuson representative.
Protecting from moisture
Protect the machine against rain, snow or any other forms of moisture. This could
cause damage or other malfunctions.
Protecting against extreme high or low temperatures
Do not expose the machine to extreme high or low temperatures. Otherwise the
insulation current conducting parts can be damaged.Information on the permis-
sible temperature range can be found in the chapter Technical data.
3.8

Safety during the operation of modular internal vibrator

Carrying belt (Accessories)
Wacker Neuson recommends the use of a carrying belt.
For further information, refer to chapter Accessories.
3.9

Maintenance

Maintenance work
Service and maintenance work must only be carried out to the extent described
in these operating instructions. All additional work, e.g., the replacement of the
power cable, must be carried out by the Wacker Neuson representative to pre-
vent any safety risks.
For further information, refer to chapter Maintenance.
Disconnecting the machine from the electric power supply
Before carrying out service or maintenance work, pull the plug out of the plug re-
ceptacle in order to disconnect the machine from the electric power supply.
100_0101_si_0004.fm
19
3 Safety