Right Coolant Pipe On Transmission, Removing And Installing - Audi Q7 2007 Repair Manual

Audi Q7 2007 ➤
6-Cylinder Direct Injection 3.0L 4V TFSI Supercharged Engine - Edition 01.2016
– Open the clamp -2- and remove the coolant hose form the
coolant pipe.
– Remove the bolt -1- and remove the coolant pipe back out of
the cylinder block in direction of -arrow-.
Installing
Install in reverse order of removal. Note the following:
• Tightening specification. Refer to
Pipes", page 195
Note
Replace the O-rings.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Clean and smooth the O-ring sealing surface.
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Coat the O-ring with coolant and slide it onto the coolant pipe.
– Connect the coolant hose to the coupling. Refer to
""Connect Coolant Hose to Coupling"" , page 216
– Install the high pressure line and the right intake manifold low‐
er section. Refer to ⇒ Fuel Injection and Ignition; Rep. Gr.
24 ; Fuel Injection System; Intake Manifold Lower Section with
Fuel Rail, Removing and Installing and ⇒ Fuel Injection and
Ignition; Rep. Gr. 24 ; Fuel Pump, Fuel Delivery Unit and Fuel
Level Sensor; Fuel Delivery Unit and Fuel Gauge Sensor
Overview .
– Fill with coolant. Refer to
3.9 Right Coolant Pipe on Transmission,
Removing and Installing
Special tools and workshop equipment required
♦ Hose Clip Pliers - VAS6340-
♦ Hose Clip Pliers - VAS6362-
Removing
Note
When installing, bring all cable ties back to same positions.
– Drain the coolant. Refer to
ing", page 184 .
– Remove the right front wheel. Refer to ⇒ Wheels and Tire
Guide; Rep. Gr. 44 ; Wheel Bolt Tightening Specifications .
– Remove the generator. Refer to ⇒ Electrical Equipment; Rep.
Gr. 27 ; Generator .
206
Rep. Gr.19 - Cooling System
⇒ "3.1 Overview - Coolant
⇒ page 186 .
⇒ "1.2 Coolant, Draining and Fill‐
⇒ Fig.
.