TigerStop TigerRack User Manual page 35

p l
rog r am m i n g a i sT
1. Start at the Ready Screen.
2. Press the [Show] soft key.
3. Press the [List] soft key.
4. Enter the list number to program and press the [Edit] soft key.
Choose a number between 1 - 100.
5. Select the type of list to program.
6. If the Dynamic Optimization upgrade is enabled, press
the list for maximum material yield. Otherwise, press
7. Select to use a global or a local head & tail cut.
Global - Uses the head & tail cut setting from the Part List menu.
Local - Set a head and tail cut that is used for this list, only.
Head & tail cuts are trim cuts at the ends of the material.
8. Enter the length of the part to process and press
9. Enter how many parts to process, followed by
TigerStop Standard Controller Basic Functions
®
to optimize
29