Omron NX Series Hardware User Manual page 82

2 System Configuration
Devices
Programmable Terminals
Servers
*1. Use an X Bus Unit.
*2. Mount to an NJ-series CPU Unit.
*3. Mount the Unit to the NX-series NX502 CPU Unit.
2-10
Connection
Servo Drives, general-purpose slaves
and Vision Systems
Ethernet communications devices
Serial communications devices
DeviceNet slaves
CompoNet slaves
Connections to BOOTP server, DNS
server, or NTP server
Connection method
Use the built-in EtherCAT port.
Use the built-in Ethernet/IP port (1 or 2) or a port on an
*1
EtherNet/IP Unit.
Mount the following Units and use RS-232C port or
RS-422A/485 ports.
•
CJ-series Serial Communications Unit
•
NX-series Communications Interface Unit
Mount a CJ-series DeviceNet Unit
Mount a CJ-series CompoNet Master Unit
CompoNet.
Use the built-in EtherNet/IP port (1 or 2) or a port on an
*1
EtherNet/IP Unit.
Use the built-in Ethernet/IP port (1 or 2) or a port on an
*1
EtherNet/IP Unit.
NX-series NX502 CPU Unit Hardware User's Manual (W629)
*2
*3
*2
and use DeviceNet.
*2
and use