Omron NX Series Hardware User Manual page 71

3) Wiring I/O
4) Connecting the
Computer That Runs
the Sysmac Studio
STEP5. Checking Operation and Starting Operation on the Actual System
Step
1) Online Connection
to Sysmac Studio and
Project Download
2) Clock Data Setting
3) Operation Check on
Controller
4) Actual Controller
Operation
*1. Use the Synchronize Menu of the Sysmac Studio to download the project.
NX-series NX502 CPU Unit Hardware User's Manual (W629)
•
Wiring I/O for NX Units
•
Wiring an X Bus Unit
•
Wiring I/O to EtherCAT slaves
•
Connecting the built-in EtherNet/IP port
Description
Turn ON the power supply to the Control-
ler and place the Sysmac Studio online.
Then, download the project.
Perform this step before you create the
slave configuration, NX Unit configura-
tion, or X Bus Unit configuration from the
mounted Units in step 2-1.
Set the clock data with the clock function
when the battery is mounted or when the
battery-free operation is performed.
1. Check the wiring by using forced re-
freshing of real I/O from the I/O Map
or Watch Tab Page.
2. For motion control, use the MC Test
Run operations in PROGRAM mode
to check the wiring. Then check the
motor rotation directions for jogging,
travel distances for relative position-
ing (e.g., for electronic gear settings),
and homing operation.
3. Change the Controller to RUN mode
and check the operation of the user
program.
Start actual operation.
1 Introduction to NX-series Controllers
Sysmac Studio
Operations
Controller −
Communications
Setup
*1
Controller −
Synchronization
Controller −
Controller Clock
---
---
Manuals for the specific NX
Units
Manuals for the specific X
Bus Units
Operation manuals for the
EtherCAT slaves
5-4 Wiring on page 5-36
Sysmac Studio Version 1
Operation Manual (Cat. No.
W504)
Reference
NJ/NX-series CPU Unit
Software User's Manual
(Cat. No. W501)
NJ/NX-series CPU Unit
Software User's Manual
(Cat. No. W501)
NJ/NX-series CPU Unit
Software User's Manual
(Cat. No. W501)
---
1-19
1