Push Button Switches; Typical Installation; Software - Connect Tech Rogue AGX101 User Manual

Push Button Switches

Function Power/Reset/Force Recovery Buttons
Location S3, S6, S5
Type Momentary Push button micro switches
Function Power ON switch (S3): a press of >500ms
when in manual mode will trigger system to
power ON.
Reset Switch (S6): a press of >500ms will
trigger a full system Reset.
Force Recovery (S5): No function during
normal operation. Will place the AGX
Xavier™ Module into Force Recovery Mode
when held during power ON.

TYPICAL INSTALLATION

1. Ensure all external system power supplies are off.
2. Install the Jetson AGX Xavier™ Module onto the Molex Mirror Mezz™ Connector. Be sure to
follow the manufacturer's directions for proper installation of mounting hardware,
heatsink/heatspreader, and any other applicable requirements from the manufacturer.
3. Install the necessary cables for application. At a minimum these would include:
a) Power cable to the input power connector on the carrier
b) HDMI video display cable
c) Keyboard and mouse via USB
For additional information on the relevant cables, please see the Cables and Interconnects section
of this manual.
4. Connect the Power Cable to the Power Supply.
5. Switch ON the Power Supply. DO NOT power up your system by plugging in live power.

SOFTWARE

For L4T (Linux for Tegra) BSPs and Software Support NVIDIA® Jetson™ AGX Xavier™ please follow this
link: https://connecttech.com/resource-center/l4t-board-support-packages/
Document: CTIM-00504
Revision: 0.05
Rogue – NVIDIA® Jetson AGX Xavier™ Carrier
Page 32 of 38
Users Guide
www.connecttech.com
Date: 2022-12-01