Inserting Or Replacing The Batteries - i-SENS CareSens Dual User Manual

m

Inserting or Replacing the Batteries

The CareSens Dual meter uses two 3.0 V lithium batteries. Before
using the meter, check the battery compartment and insert
batteries if empty.
When the
in use, the batteries should be replaced as soon as possible. The
test results may not be saved if the batteries run out.
Step 1
Make sure the meter is turned off. Push the
cover in the direction of the arrow to open
the battery compartment.
Step 2
Remove the used batteries one at a time.
Slip your index finger under the battery to
lift and pull out as shown. Insert two new
batteries with the + side facing up and make
sure the batteries are inserted firmly.
Step 3
Place the cover on the battery
compartment. Push it down until you hear
the tab click into place.
Note:
Removing the meter batteries will not affect your stored
results. However you may need to reset your meter settings.
See page 19.
symbol appears on the display while the meter is
www.i-sens.com 11