Creality Laser Module Quick Start Manual page 18

预览模式下， 再次按下微动开关， 机器进入雕刻模式， 此时激光头会发出强光， 机器开始雕刻， 指示灯常亮。
如果需要暂停雕刻， 请按下微动开关， 此时指示灯变成呼吸灯效果， 再次按下微动开关可以继续雕刻。
如果需要取消雕刻， 请长按微动开关 3 秒， 机器会发出"滴"一声， 随后机器复位， 复位完成机器发出"滴 ... 滴"两声， 进入待机模
式， 指示灯变成呼吸灯效果。
In preview mode, press microswitch again, it will enter engraving mode. At this time, the laser head will
emit a corresponding level of laser power, the machine will start engraving with indicator light on.
If you need to cancel the engraving,please press and hold the microswitch for 3 seconds, it will "beep"
once, then it will return to home position, and "beep" twice after reset is completed. Enter standby mode, the
indicator light returns into flashing light.
If you need to cancel the engraving,please press and hold the microswitch for 3 seconds, it will "beep"
once, then it will return to home position, and "beep" twice after reset is completed. Enter standby mode, the
indicator light returns into flashing light.
3. 雕刻完成后， 机器会长"滴"三声， 随后机器复位， 复位完成机器发出"滴 ... 滴"两声， 进入待机模式， 指示灯变成呼吸灯效果。
3.After engraving is completed, it will "beep" three times and return to home position then it "beeps" twice,
enters standby mode, and the indicator light turns into flashing light .
指示灯状态说明
Indicator Status
1. 指示灯灭：机器处于断电状态， 或上电异常。
2. 呼吸灯效果：机器处于待机模式， 可按下微动开关进入预览模式或雕刻模式。
3. 指示灯闪烁：机器处于升级模式， 同时蜂鸣器发出急促的响声， 等待升级完成后自动进入待机模式。
4. 指示灯常亮：机器处于预览模式或雕刻模式， 此时激光头处于出光状态， 需格外注意安全。
1. Light off: The machine is in a power-off state, or the power is abnormal.
2. Slow Flashing light: The machine is in standby mode, you can press the microswitch to enter preview mode or
engraving mode.
3. Fast Light flashes: the machine is in upgrade mode, and the buzzer beeps quickly, and it will automatically enter
standby mode after the upgrade is completed.
4. Light always on: the machine is in preview mode or engraving mode. The laser head is working, please pay attention to
safety.