Javad TRIUMPH-2 Manual page 3

Pairing the Radio
Your radio (HPTxxxBT) and the TRIUMPH-2 receiver come
from the factory already paired and ready to communicate
with each other out of the box. Once powered, both the
radio and receiver will show their blue LEDs lit indicating
their linked communications. Usually this only takes a few
seconds.
When you purchase a radio from Javad GNSS separately
from the purchase of the receiver,
establish their pairing. It can also be used in establishing a
pairing with multiple radios in the series which include: the
HPT901BT*, HPT401BT, HPT404BT and the HPT435BT.
www.javad.com
NetView is available to
Pairing the Radio
* Note: The TRIUMPH-2 paired with the HPT901BT works as a UHF
base for the TRIUMPH-LS when the FH915 radio has been installed
at the factory on the TRIUMPH-LS.
Procedure
Step 1. Connect the TRIUMPH-2 to your PC using the USB ca-
ble: USB Cable, A / micro B, (3.3 ft / 1.0 m) [14-578156-01].
Power the TRIUMPH-2 on.
Step 2. Connect the HPTxxxBT to your PC via a serial port
or through a USB to serial adapter. Be sure to connect the
antenna before powering the radio on. Depending on your
radio, the following cable choices will then apply:
3