Table of Contents
Advertisement
1.2 INSTALLATION
EyeZen RF it is entirely powered through a battery. The communication with the other
devices of the installation is carried out through the RF antenna that incorporates inside.
The main elements of the device are described next.
Programming button (3): a short press on this button sets the device into the
programming mode, making the associated LED (4) light in red.
Note: if this button is held while plugging the battery, the device will enter the
safe mode. In such case, the LED will blink in red every 0.5 seconds.
Detection notification LED (1): emits a red light flash when the sensor
observes motion.
To get detailed information about the technical features of this device, as well as on the
installation process and on security procedures, please refer to the corresponding
Datasheet, bundled with the original packaging of the device and also available at
www.zennio.com.
https://www.zennio.com
Figure 1. EyeZen RF. Elements
Technical Support:
1. Detection LED indicator.
2. Retaining spring.
3. Programming button.
4. Programming LED.
5. Battery compartment.
https://support.zennio.com
EyeZen RF
4
Advertisement
Table of Contents
