Table of Contents
Advertisement
1.2 INSTALLATION
EyeZen TP v2 connects to the KNX bus through the on-board KNX connector.
Once the device is provided with power from the KNX bus, both the individual address
and the associated application program may be downloaded.
This device does not need any additional external power since it is entirely powered
through the KNX bus.
The main elements of the device are described next.
Programming button (3): a short press on this button sets the device into the
programming mode, making the associated LED (4) light in red.
Note: if this button is held while plugging the device into the KNX bus, the device
will enter the safe mode. In such case, the LED will blink in red every 0.5
seconds.
Detection notification LED (1): emits a red light flash when the sensor
observes motion.
https://www.zennio.com
Figure 1. EyeZen TP v2. Elements
Technical Support:
1. Detection LED indicator.
2. Retaining spring.
3. Test/Prog. button.
4. Test/Prog. LED.
5. KNX connector.
https://support.zennio.com
EyeZen TP v2
4
Advertisement
Table of Contents
