HVAC Mode [enabled / disabled] (only if the "HVAC Control" is enabled):
enables or disables the sending of a special HVAC mode value (as set in
Value) through the "Motion (HVAC)" object:
Sending Mode
also be shown:
➢ Period [60...255][s] [1...255][min] [1...18][h].
Note: With the aim of increase the battery life of the device, only in "Detection"
state will be possible set periodic sending. In addition, the shorter the sending
period, the shorter the life of the battery.
Delay [0...255][s/min] [0...18][h]: sets a delay between the detection state
switchover and the actual sending to the bus.
https://www.zennio.com
HVAC Mode
Auto
Comfort
Standby
Economy
Building Protection
Table 2. HVAC modes
[Once
/ Cyclic]: if the latter is selected, the following field will
Object value
0
1
2
3
4
Technical Support:
https://support.zennio.com
EyeZen RF
13