Related Manuals for Zennio WinDoor RF
Summary of Contents for Zennio WinDoor RF
- Page 1 WinDoor RF / WinDoor RF 915 KNX-RF magnetic contact for door or window ZRFWD ZRFWD915 Application program version: [1.1] User manual edition: [1.1]_a www.zennio.com...
-
Page 2: Table Of Contents
WinDoor RF / WinDoor RF 915 CONTENTS Contents ............................2 Document updates ........................3 Introduction .......................... 4 WinDoor RF / WinDoor RF 915 ..................4 Installation ........................5 Device programming ..................... 6 Start-up and power loss ....................6 Configuration......................... 7 General .......................... -
Page 3: Document Updates
WinDoor RF / WinDoor RF 915 DOCUMENT UPDATES Version Changes Page(s) [1.1]_a Internal optimisation. https://www.zennio.com Technical Support: https://support.zennio.com... -
Page 4: Introduction
1 INTRODUCTION 1.1 WinDoor RF / WinDoor RF 915 WinDoor RF or WinDoor RF 915 from Zennio is a device that detects and notifies the opening and closing of doors and windows, communicating completely wirelessly by radio frequency. This device is designed to be placed in the frame of doors and windows easily. -
Page 5: Installation
WinDoor RF / WinDoor RF 915 1.2 INSTALLATION WinDoor RF it is entirely powered through a battery. The communication with the other devices of the installation is carried out through the RF antenna that incorporates inside. Antenna RF º 3º... -
Page 6: Device Programming
Once the battery is connected, downloading both the physical address and the application program will be possible. To do this WinDoor RF must be in “active” state. As long as there are no open/close events, the WinDoor RF remains in a low... -
Page 7: Configuration
WinDoor RF / WinDoor RF 915 2 CONFIGURATION After importing the corresponding database in ETS and adding the device into the topology of the desired project, the configuration process begins by entering the parameters window of the device. 2.1 GENERAL In “General”... - Page 8 Note: higher transmission power increases the transmission distance of the WinDoor RF but also shortens battery life. Heartbeat (Periodic Alive Notification) [enabled/disabled]: incorporates a one-bit object to the project (“[Heartbeat] Object to Send ‘1’”) that will be sent periodically with a value of “1”...
- Page 9 WinDoor RF / WinDoor RF 915 Tamper [enabled/disabled]: enables the object “Alarm: Tamper Alarm: (Status)” through which a '1' is sent when the device enclosure is removed. Note: the tamper alarm will be sent 5 times after each change of state or reset.
-
Page 10: Annex I. Communication Objects
WinDoor RF / WinDoor RF 915 ANNEX I. COMMUNICATION OBJECTS “Functional range” shows the values that, with independence of any other values permitted by the bus according to the object size, may be of any use or have a particular meaning because of the specifications or restrictions from both the KNX standard or the application program itself. - Page 11 Join and send us your inquiries about Zennio devices: https://support.zennio.com Zennio Avance y Tecnología S.L. C/ Río Jarama, 132. Nave P-8.11 45007 Toledo (Spain). Tel. +34 925 232 002. www.zennio.com info@zennio.com...