Table of Contents
Advertisement
2 CONFIGURATION
After importing the corresponding database in ETS and adding the device into the
topology of the desired project, the configuration process begins by entering the
parameters window of the device.
2.1 GENERAL
In "General" tab all the functionality of the device will be configured, with the exception
of the motion detection functionality, which will be configured in a separated tab.
Therefore, since this tab it will be possible configure the power of the radio frequency
transmission, the lens color, Heartbeat and two alarms:
Transmission power: sets the distance and the power of the radio frequency
links.
Lens color: sets the color of the lens of the device
Tamper: notifies whether the device has been tampered with by removing its
enclosure.
Battery: warns the user when the battery level is about to run out.
ETS PARAMETERISATION
From General screen it is possible to activate/deactivate all the required functionality.
Transmission Power [Minimum /
transmission power of the device.
1
The default values of each parameter will be highlighted in blue in this document, as follows:
[default/rest of options].
https://www.zennio.com
Figure 2. General
Medium
/ Maximum]
Technical Support:
EyeZen RF
1
: allows to set the
https://support.zennio.com
6
Advertisement
Table of Contents
