Table of Contents
Advertisement
Note: higher transmission power increases the transmission distance of the
EyeZen RF but also shortens battery life.
Lens Color
installed, will allow a correct performing of the device.
Alarm: Tamper [enabled / disabled]: enables the object "Alarm: Tamper"
through which an 'Alarm' is sent when the battery cover is removed, and 'No
Alarm' when it is replaced
Note: the tamper alarm will be sent 5 times with a period of 2 seconds after
each change of state.
Alarm: Battery [enabled / disabled]: enables the object "Alarm: Battery
(Status)" through which a '1' is sent when the battery level is about to run out.
Note: the battery alarm will be sent periodically every day, while the 'No alarm'
notification will be sent only once. After each device reset the battery state will
be notified
Heartbeat (Periodic Alive Notification) [enabled / disabled]: incorporates a
one-bit object to the project ("[Heartbeat] Object to Send '1'") that will be sent
periodically with a value of "1" to notify that the device is still working (still alive).
Note: the first sending after download or bus failure takes place with a delay of
up to 255 seconds, to prevent bus overload. The following sending match the
period set.
Note: with the aim of increase the battery life, Heartbeat will only be configurable
in days.
https://www.zennio.com
[White
/ Black]. selecting the lens color that EyeZen RF has
Figure 3. Heartbeat
Technical Support:
https://support.zennio.com
EyeZen RF
7
Advertisement
Table of Contents
