Table of Contents
Advertisement
1.2 INSTALLATION
WinDoor RF it is entirely powered through a battery. The communication with the other
devices of the installation is carried out through the RF antenna that incorporates inside.
6
7
The main elements of the device are described next:
Programming button (3): a short press on this button sets the device into the
programming mode, making the associated LED (2) light in red.
Note: if this button is held while plugging the battery, the device will enter the
safe mode. In such case, the LED will blink in red every 0.5 seconds.
Tamper sensor (6): allows to detect if the device enclosure has been tampered
with.
To get detailed information about the technical features of this device, as well as on the
installation process and on security procedures, please refer to the corresponding
Datasheet, bundled with the original packaging of the device and also available at
www.zennio.com.
https://www.zennio.com
3
1
2
4
º
º
3
Figure 1. WinDoor RF elements
WinDoor RF / WinDoor RF 915
5
1.
Antenna RF
3º
2.
Programming LED
3.
Programming button
4.
Battery
5.
Cover
6.
Tamper button
7.
Magnet
Technical Support:
https://support.zennio.com
5
Advertisement
Table of Contents
