Sanus Systems VMTV Assembly Instructions Manual page 5

Diagram 1
1] Find a stud:
The Wall Plate (a) must be mounted to a wood stud. Use a high quality stud sensor to locate the stud. It is a good idea to
verify where the stud is located with an awl or thin nail as shown in Diagram 1. Make sure the Wall Plate is oriented so that
the two tabs are close to the bottom as seen in Diagram 2. Use the Wall Plate as a template to mark the 4 hole locations for
the Lag Bolts (b) between the two edges of the chosen stud. Pre-drill four holes 2.5" deep at the marked locations using a
7/32" drill bit.
2] Mount the Wall Plate:
Attach the Wall Plate to the wall using all 4 of the Lag Bolts as shown in diagram 2.
WARNING: Tighten Lag Bolts (b) only until the Wall Plate (a) is pulled firmly against the wall. DO NOT OVER-
TIGHTEN THE LAG BOLTS!
Diagram 3
Two holes
c
e
3] Add the Arm:
Place the round part of the Arm (c) between the tabs on the Wall Plate (a) so that two holes show on top at the other end.
Place the Arm Pivot Bolt (d) down through the two tabs on the Wall Plate and through the hole in the round side of the Arm.
Thread the Arm Pivot Nut (e) onto the bottom of the Arm Pivot Bolt and tighten with a wrench as shown in diagram 3.
Note: Make sure the Arm Pivot Nut is tight, but still allows you to rotate the Arm.
4] Add the Wall Plate Cover:
Place the Wall Plate Cover (f) over the Arm (c) and snap it onto the Wall Plate as shown in diagram 4.
d
a
Diagram 2
a
b
Diagram 4
f
c