ENGLISH
•
After having reached the value, move the driving ring nut (15) to
tension the clearing adjustment spring (14), insert the potentiome-
ter (8) in its housing and fix it with the screws (12), making sure
that the value that is found remains the same. For little adjust-
ments, slightly loosen screws (12) and turn the potentiometer (8).
•
Using the microswitch (4), place the servomotor to the maximum
position by verifying that the value in "digits" increases gradually
until it reaches the maximum value expressed in the plate (9);
if this value will not be reached, the servomotor stroke will be
considered insufficient.To increase the servo motor stroke, act on
the maximum end stroke adjustment cam (2).
(2) Maximum end-of-stroke regulation cam.
(3) Minimum end-of-stroke regulation cam.
(4) Microswitch for manual control to min. position.
(5) Microswitch for manual control to max. position.
(6) Manual - automatic switch.
(8) Feed back potentiometer
(9) Adhesive plate.
(11) Potentiometer ring.
(12) Fixing screw.
(14) Clearance adjustment spring.
(15) Driving ring nut.
14
15
12
11
4
5
6
24 / 34
0006160448_202302
9
8
12
3
2