Snmp - RT Systems TM3 Installation And User Manual

SNMP

The TM3 Monitoring Units implements SNMPv1 and SNMPv3 selectable on the SNMP Configuration Page.
SNMPv3 has the advantage of authentication above SNMPv1.
The following SNMP functionality is available on the TM3 Monitoring Unit.
Refer to the TM3 MIB.txt file supplied on the utility disc. The TM3 unit has been tested on the following freeware MIB browsers:
1. iReasoning
2. Whats up Gold
3. Service Check
sensor reading:
Read or Get of all four temperature sensor values and 4-20mA sensor values.
sensor alarm thresholds:
Read or Get and Set on all four temperature sensors for critical and non-critical thresholds as well as the 4-20mA thresholds.
1 2
alarm status:
Read or Get and Walk of all alarms 1 to 34 alarm status. This includes all temperature sensors, 4-20mA sensors, Flood Sensors, TM
3
Unit, DC voltage, Mains Power, Discrete Input Alarms and Relay Status.
traps:
Traps are sent for all alarms 1 to 34 as described above.
4
Note 1: Get is an SNMP function to retrieve data from the unit.
Note 2: Set is an SNMP function to modify data on the unit.
Note 3: Walk is an SNMP function to retrieve all the status data from the unit.
Note 4: Traps are SNMP messages of alarm triggers, transmitted by the unit to a network management system which monitors the
unit outputs.
50