Menu In Off-Line Mode - GCC Technologies Puma III Series User Manual

3.3

Menu in Off-line Mode

Press [ON/OFF LINE] to switch to the offline mode
Offline For
System Setup
[ FORCE]
[ OFFSET ]
[ DATA CLEAR ]
[ ]
[ SPEED ]
[CUT TEST ]
[TOOL SELECT ]
[ MISC ]
Firmware： x.x.xx
FPGA：Vx.x
Auto Unrolled Media
Select:
Media Back & Forth
Select:
Paper Saving Mode
Select:
Set Communication
Select:
Select Language
Select:
Select Unit
Select:
Scale Length
Select:
Scale Width
Select:
AAS Offset
Select:
The Control Panel
Force: 80 gf
OK:ENTER
Offset: 0.275 mm
OK:ENTER
Clear Data Memory
N:Cancel OK:ENTER
move origin
X: Y:
Speed: 51 cm/s
Select: OK:ENTER
使用 选择
UP Speed: 51 cm/s
Select: OK:ENTER
Quality: Fine
Select: OK:ENTER
mm/dd/yy
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
OK:ENTER
5~400 with an increment of 5(gram force)
0.000~1.000 with an increment of 0.025(mm)
Speed:3~60 with an increment of 3(cm/s)
:3~60 with an increment of 3(cm/s)
UP Speed
Draft, Fine
1S:51 F:80 O:0.275 M
Select: OK:ENTER
Set Smoothing Cut
Select: OK:ENTER
OverCut: 0.00mm
Select: OK:ENTER
Set Tangential Mode
Select: OK:ENTER
Panel Setup
Select: OK:ENTER
Restore default ?
Select: OK:ENTER
Save parameter ?
Select: OK:ENTER
Both Expanded Mode、Length Expanded Mode、
Width Expanded Mode、Both Unexpanded Mode
English,Spanish,Italian,Deutsch,Japanese,Portugue
se,Polish,Turkish,French
Metric (cm/gf) or English
measurement (inch/oz)
3-3
Puma III User Manual
Square Cut
Select: OK:ENTER
Repeat Last Plot
Select: OK:ENTER
Mark Positions
Select: OK:ENTER
OverCut:0.00-1.00mm with an
increment of 0.05mm