GCC Technologies Puma III Series User Manual page 15

Puma III User Manual
Step 4
Move the cutting plotter from the carton. Put it on the stand, then
Insert the screws into the holes on plotter's bottom as Figure 2-8.
Figure 2-8
Step 5
Insert the roll holder support with the screws into the holes of the stand then
tighten them as Figure 2-9. You can decide roll holder support's position by
inserting into different holes.
Figure 2-9
Step 6
Place two roll holders into the holes in the roll holder support (Figure 2-10).
Figure 2-10
Installation 2-5